Oculus Prime - DIY Kit

With the do-it-yourself kit, you can build Oculus Prime in either the SLAM Navigator version OR the Pi Explorer version (or your own variant). Everything required is included, except for computer hardware. Comes with both sets of parts, for with-or-without depth sensor mounting, and hole patterns for mounting a mini-ITX or Raspberry Pi board.

Kit Includes: ABS Plastic Frame Set, including dock, with both non-sensor and Orbbec Astra depth camera mount parts NOTE: Asus Xtion depth camera mount can be provided upon request, just let us know after ordering LiPo battery 5000 mAh 3S AC/DC adapter: input 100v-240v 50/60hz 1.5A, output 15v / 4A Microsoft LifeCam Cinema Camera 4 x 12V Wheel Motors, incl. 1x Encoder 4 x Wheels + Aluminum Hub Adapters 2x Cree XRE LED with Leads Attached Dock Marker Decal (pre-applied) Xaxxon POWERv2 Battery Charger PCB Xaxxon MALGv3 Motor Controller PCB Cables: 2 x USB, MOLEX female > male extension (MALG PCB Power) Speaker Wires, Fasteners, misc Hardware Complete List (pdf)

Required but NOT included: Assembly, Calibration OS and Software Installation Required for SLAM Navigator version: Motherboard PSU for motherboard (if required) RAM and SSD Wifi and Antennas Depth Camera See suggested PC hardware shopping links Required for Pi Explorer Version: Raspberry Pi 2B (or higher) single board computer Micro SD card, minimum 8Gb USB Wifi Module, if required Power Adapter: 9-16V wide-input to 5V output buck 1A minimum (example) Initial setup requires monitor + keyboard + mouse

Choice of Colours: